Models 2A0110 To 2A0250, 4A0208 To 4A0675, And 5A0125 To 5A0242 (Ip00/Open Type Enclosure) - YASKAWA P1000 Quick Start Manual

3.3 Terminal Cover
u Models 2A0110 to 2A0250, 4A0208 to 4A0675, and 5A0125 to 5A0242 (IP00/Open Type
Enclosure)
Removing the Terminal Cover
n
1.
Loosen the screws on the terminal cover, then pull down on the cover.
Note: The terminal cover and the number of terminal cover screws differ depending on the drive model.
Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
CAUTION!
cover may fall off causing an injury.
Figure 3.12 Removing the Terminal Cover on an IP00/Open Type Enclosure Drive
2.
Pull forward on the terminal cover to free it from the drive.
Figure 3.13 Removing the Terminal Cover on an IP00/Open Type Enclosure Drive
Reattaching the Terminal Cover
n
After wiring the terminal board and other devices, double-check connections and reattach the terminal cover.
the Main Circuit Terminal on page 65
Figure 3.14 Reattaching the Terminal Cover on an IP00/Open Type Enclosure Drive
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
50
and Wiring the Control Circuit Terminal
<1>
YASKAWA ELECTRIC TOEP YAIP1U 01B YASKAWA AC Drive - P1000 Quick Start Guide
Refer to Wiring
on page 69 for details on wiring.