Operator Programming Errors; Operator Programming Errors; Operator Programming Error Codes, Causes, And Possible Solutions - YASKAWA P1000 Quick Start Manual

5.4

Operator Programming Errors

Operator Programming Error Codes, Causes, and Possible Solutions

u
An Operator Programming Error (oPE) occurs when a contradictory parameter is set or an individual parameter is set to an
inappropriate value.
The drive will not operate until the parameter or parameters causing the problem are set correctly. An oPE, however, does not
trigger an alarm or fault output. If an oPE occurs, investigate the cause and refer to
an oPE appears on the operator display, press the ENTER button to view U1-18 and see which parameter is causing the oPE.
Digital Operator Display
oPE28
YASKAWA ELECTRIC TOEP YAIP1U 01B YASKAWA AC Drive - P1000 Quick Start Guide
Table 5.4 oPE Codes, Causes, and Possible Solutions
Drive Capacity Setting Fault
oPE01
Drive capacity and the value set to o2-04 do not match.
Parameter Range Setting Error
oPE02
Use U1-18 to find parameters set outside the range.
Multi-Function Input Selection Error
oPE03
A contradictory setting is assigned to multi-function contact inputs H1-01
to H1-08.
oPE04 Initialization Required, Term <–> Ctrl Chg
oPE05 Run Command/Frequency Reference Source Selection Error
Multi-Function Analog Input Selection Error
oPE07
A contradictory setting is assigned to multi-function analog inputs H3-02,
H3-10, or H3-06 and PID functions conflict.
PID Control Selection Fault
oPE09
PID control function selection is incorrect. Requires that PID control is
enabled (b5-01 = 1 to 4).
V/f Data Setting Error
oPE10
One of the following setting errors has occurred:
E1-09 ≤ E1-07 < E1-06 ≤ E1-11 ≤ E1-04
Carrier Frequency Setting Error
oPE11
Correct the setting for the carrier frequency.
Sequence Timer Error
oPE28
One or more of the sequence timers is not set in the correct order.

5.4 Operator Programming Errors

Table 5.4 for the appropriate action. When
Error Name
5
149