Honda HS1810Z Owner's Manual page 93

Fuse
In the event of a burned out fuse, replace it with another fuse of the
rated capacity only after investigating the cause for the failure. If the
fuse is replaced without correcting the reason for the failure, the new
fuse may burn out quickly again.
Never replace a burned out fuse with any object other than another
fuse of the rated capacity. Using any other object such as wire or
aluminum foil may cause fires in wiring or other parts.
Block fuse replacement requires specific tools. Ask an authorized
Honda dealer for replacement.
Fuse replacement (blade fuse only)
1. Remove the left side cover (see page 34 or 35).
2. Replace the blown blade fuse with a new one (3 A, 10 A or 30 A).
Additional fuses are available from an authorized Honda dealer.
Have the 30 A and 60 A block fuses checked and replaced by an
authorized Honda dealer.
3. Reinstall the left side cover (see page 34 or 35 ).
30 A (CHUTER)
Burned out
must be replaced
90
30 A (AUGER CLUTCH)
10 A (ENGINE SWITCH)
3 A (CLUTCH CONTROL)
60 A (AUGER HEIGHT/ROLLING)
Burned out
must be replaced
30 A (MAIN)