Change Sensor Names - Interlogix zerowire ZW-6400 User Manual

To bypass a sensor using the ZeroWire panel:
1.
USER PIN
2.
CODE
3. ZONE NUMBER
4.
0
MENU
5.
After bypassing your selected sensors, your security system must be armed
(turned on) in either the away or stay mode to secure the remaining sensors.
The status light will turn to yellow to indicate there are one or more bypassed
sensors. Touch the status key to check which sensors are bypassed.

2.14 Change Sensor Names

You can change the names of your sensors in the Settings Selector
menu.
From the UltraSync app press the
You are on the
Select the sensor you wish to name and type the new name in the box as
shown below. Remember to save your changes.
C
... 26
...
ENTER
ENTER
ZeroWire User Guide
Select Bypass Menu.
Enter PIN code with authority to
bypass.
Select a zone to bypass.
Toggle between un-bypassed to
bypassed state.
Exits from Bypass Menu.
button then
page.
I
.. ...
... ..