Mute, Outputs 1&2, Trim, Output Meters; Headphone Jack - McIntosh D1100 Owner's Manual

How to Operate the D1100, con't
1. Momentarily press the INPUT Control, then rotate
it to select "HEADPHONE HXD, On". Refer to
figure 74.
HEADPHONE HXD
On
Figure 74
2. To deactivate the HXD Mode rotate the VOL-
UME Adjust Control until the Front Panel Display
indicates "HEADPHONE HXD, Off". Refer to
figure 75.
HEADPHONE HXD
Off
Figure 75
Mute
Press the MUTE Push-button, on the D1100 Front
Panel or on the Remote Control, to Mute the Audio
in all outputs (Output 1, Output 2 and Headphones)
except the FIXED OUTPUT. The Front Panel Infor-
mation Display will indicate the Source Name and
the word MUTE in place of the actual volume setting.
Refer to figure 76.
22
OPTI 2
44.1kHz
Figure 76
Pressing the Mute Push-button a second time or
adjusting the volume control (either the Front Panel or
Remote Control) will unmute the D1100.
Output 1 and 2
Press the Front Panel OUTPUT 1 or OUTPUT 2
Push-button or use the Remote Control and press the
SETUP/BLUE Push-button followed by the OUTPUT
1 or OUTPUT 2 Push-button, to send audio to sepa-
rate Power Amplifiers connected to the rear panel
OUTPUT 1 or 2 Connectors/Jacks. It also activates the
POWER CONTROL TRIGger 1 or 2 Jacks on the rear
panel of the D1100. To stop the Audio and Power Con-
trol Signals from going to the separate Power Ampli-
fiers, press the same Push-button(s) a second time.
Trim
Momentarily press the Front Panel INPUT Control to
activate the D1100 Trim Functions. Rotate the INPUT
Figure 61
Control to select the desired Trim Function and then
MUTE
use the VOLUME (adjust) Control to change the Trim
setting. Refer to figure 61. The Remote Control TRIM
and LEVEL UP / DOWN Push-buttons may also be
used. Refer to figure 64 on page 20. Approximately 7
seconds after Trim Function Selection and/or adjust-
ments have stopped, the D1100 will switch the Trim
Mode Off.
Output Meters
The D1100 Output Meters indicate the variable Output
Level in Decibels (dB) available at the OUTPUT 1 and
2 Connectors/Jacks to drive Power Amplifiers. When
the D1100 is in the Digital Preamplifier Mode, the
TRIM "METER LEVEL" setting allows the Output
Meters to monitor the FIXED OUTPUT Connectors/
Jacks instead of the OUTPUT 1 and 2 variable output.
Refer to figure 77. The Meters are calibrated in dB
(decibels) and respond to all the peaks contained in the
musical information. A meter reading of 0dB indicates
the D1100 is delivering its rated output.
Headphones Jack
Connect a pair of dynamic headphones to the Head-
phones Jack with a 1/4" (0.635cm) stereo phone type
plug for private listening. The default setting is for all
of the Power Amplifier Output Connections (1 and 2)
Figure 77