How To Use The Hr085 Remote Control - McIntosh D1100 Owner's Manual

How to use the Remote Control
The supplied D1100 Remote Control (HR085) is ca-
pable of directly controlling the functions of contem-
porary McIntosh Source Components connected to the
D1100 via the Data Ports.
Notes: 1. If at any time the D1100 seems unresponsive
to the HR085 Remote Control Commands,
press the DEVICE Push-button to select
first.
2. For additional information on using the
HR085 Remote Control, please refer to the
"How to Operate" starting on page 20.
3. For additional information on assigning the
Data Ports, refer to "How to Setup" on page
13.
Trim
Press the TRIM Push-button until the desired Trim
function (Balance, Trim Level, etc.) appears on the
D1100 Front Panel Display, then press the LEVEL Up
or Down Push-button to adjust the Trim setting.
Note: Press the TRIM Push-button to recall the last Trim
function selected. For additional information on
using the Trim Functions refer to "How to Oper-
ate" page 20.
Output Selection
Press the BLUE (Setup) Push-button followed by
the AM (Output 1) or FM (Output 2) Push-button, to
control the Rear Panel Audio OUTPUTS 1, 2 (ON or
OFF) and Power Control TRIG 1 / TRIG 2.
Note: For additional information on assigning the Out-
puts (1 and 2) and Power Control Triggers (1 and
2) refer to pages 15 and 16.

How to use the HR085 Remote Control

11