Table of Contents
Advertisement
Changing the vehicle-to-vehicle distance (vehicle-to-vehicle distance
control mode)
Pressing the button changes the vehi-
cle-to-vehicle distance as follows:
Long
1
Medium
2
Short
3
The vehicle-to-vehicle distance is set
automatically to long mode when the
power switch is turned to ON mode.
If a vehicle is running ahead of you, the preceding vehicle mark will also be displayed.
Vehicle-to-vehicle distance settings (vehicle-to-vehicle distance con-
trol mode)
Select a distance from the table below. Note that the distances shown corre-
spond to a vehicle speed of 50 mph (80 km/h). Vehicle-to-vehicle distance
increases/decreases in accordance with vehicle speed. When the vehicle is
stopped by system control, the vehicle-to-vehicle distance will be about 16 ft.
(5 m) to 23 ft. (7 m) regardless of the vehicle-to-vehicle distance setting.
Distance options
Resuming follow-up cruising when the vehicle has been stopped by sys-
tem control (vehicle-to-vehicle distance control mode)
After the vehicle ahead of you starts off,
push the lever up.
Your vehicle will also resume follow-up
cruising if the accelerator pedal is
depressed after the vehicle ahead of
you starts off.
GS450h_OM_OM30E99U_(U)
4-5. Using the driving support systems
Long
Medium
Short
Preceding
vehicle mark
Vehicle-to-vehicle distance
Approximately 160 ft. (50 m)
Approximately 130 ft. (40 m)
Approximately 100 ft. (30 m)
247
4
Advertisement
Table of Contents
