❋
VARI
LITE® - VL3500™ W
Tilt EOT Sensor Replacement
23.9661.1253
Parts:
Repair Procedure
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At tilt-side leg, remove yoke leg cover by removing four 6-32 x 5/16" PTB screws.
Step 3. As shown in
remove bracket.
Step 4. Disconnect wiring from tilt encoder board.
Step 5. At sensor, remove two 6-32 x 3/8" PPZ screws and remove sensor from bracket.
Step 6. Replace by performing steps 2 through 5 in reverse order.
50
L
S
ASH
UMINAIRE
ERVICE
Figure
2-19, at the sensor bracket, remove two 10-32 x 1/2" PPZ screws and
Sensor
Sensor
Bracket
Figure 2-19: Tilt EOT Sensor Replacement
M
ANUAL
02 .9 686 .00 10 A