Sound-Active Mode; Sound Sensitivity; Preset Color Mode; Tilt Setting - Chauvet COLORBAND PIX-M USB User Manual

O
PERATION

Sound-Active Mode

To run the COLORband PiX-M USB in sound-active mode, follow the instructions below:
1. Press <MENU> repeatedly until Snd shows on the display.
2. Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).

Sound Sensitivity

To set the sound sensitivity on the COLORband PiX-M USB, do the following:
1. Press <MENU> repeatedly until Sens shows on the display.
2. Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from u 0–100.
3. Press <ENTER>.

Preset Color Mode

To run the COLORband PiX-M USB on a static color, follow the instructions below:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select a static color, from C 1–18.
4. Press <ENTER>.

Tilt Setting

To set a static position of the tilt on the COLORband PiX-M USB, do the following:
1. Press <MENU> repeatedly until t-- shows on the display.
2. Use <UP> or <DOWN> to increase or decrease the tilt value, from t 0–50.
3. Press <ENTER>.
To set the tilt on the COLORband PiX-M USB to rotate automatically, follow the instructions below:
1. Press <MENU> repeatedly until t-- shows on the display.
2. Use <UP> or <DOWN> to increase or decrease the tilt speed, from t 51–100.
3. Press <ENTER>.

Custom Color Mixing

To custom mix a static color, do the following:
1. Press <MENU> repeatedly until u-- shows on the display.
2. Press <ENTER> and r_ _ _ (red), g_ _ _ (green), or b_ _ _ (blue) will show on the display.
3. Press <ENTER> to cycle through the settings.
4. When the desired setting shows on the display, use <UP> or <DOWN> to increase or decrease
the color value, from 000–255.
5. Repeat steps 3 and 4 until the product outputs as desired.

Dimmer Speed Mode

To set the dimmer speed mode of the COLORband PiX-M USB, follow the instructions below:
1. Press <MENU> repeatedly until dIM shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select from OFF (linear dimming), dIM1 (fast dimming), dIM2 (medium
dimming), or dIM3 (slow dimming).
4. Press <ENTER>.

Tilt Offset

To set the tilt offset of the COLORband PiX-M USB, do the following:
1. Press <MENU> repeatedly until OFF shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the tilt offset, from 0–255.
4. Press <ENTER>.
COLORband PiX-M USB User Manual Rev. 1 Page 14 of 20