Fault Reason Responses - Cisco BTS 10200 Troubleshooting Manual

Command Responses

Fault Reason Responses

The following responses can be returned for the fault reason (fault-reason) response for a subscriber
termination command. One or more values can be returned, depending upon the operating conditions
of the Call Agent.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
14-14
The media gateway is down.
The media gateway is unreachable.
The media gateway is in a faulty state.
The media gateway is transitioning to another state.
The transaction could not be executed, due to a transient error.
The transaction could not be executed because the endpoint is unknown.
The transaction could not be executed because the endpoint is not ready.
The transaction could not be executed, endpoint does not have enough resources available.
The transaction could not be executed because a protocol error was detected.
The transaction could not be executed because the command contained an unrecognized extension.
The transaction could not be executed because the gateway is not equipped to detect one of the
requested events.
The transaction could not be executed because the gateway is not equipped to generate one of the
requested signals.
The transaction could not be executed because the gateway cannot send the specified announcement.
Invalid conn identifier.
Invalid call ID.
Unsupported mode or invalid mode.
Unsupported or unknown package.
Endpoint does not have a digit map.
The transaction could not be executed because the endpoint is restarting.
Endpoint redirected to another Call Agent.
No such event or signal.
Unknown action or illegal combination of actions.
Internal consistency in local connection options.
Unknown extensions in local connection options.
Insufficient bandwidth.
Missing remote connection descriptor.
Incompatible protocol version.
Internal hardware failure.
CAS signaling protocol error.
Failure of a group of trunks.
Unsupported values on local connection options.
Response too big.
Chapter 14 General Troubleshooting
OL-8723-19