Carrier Assembly Removal - Lexmark S 500 SERIES Service Manual

Lexmark S500 Series

Carrier assembly removal

1. Remove the scanner assembly. See
2. Remove the midframe. See
3. Remove the operator panel. See
4. Remove the RFID card. See
5. Remove the system board. See
6. Disconnect the encoder strip (A), and the clip (B) from the right side of the carrier assembly.
Note: Pay close attention to the direction of the arrow on the encoder strip before removing. The arrow on the
encoder strip needs to point up when reinstalling.
7. Remove the two screws (C) from the purge pump.
4-28
Service Manual
"Scanner assembly removal" on page
"Midframe removal" on page
"Operator panel removal" on page
"RFID card removal" on page
"System board removal" on page
B
C
4-3.
4-10.
4-18.
4-19.
4-26.
A