Lexmark S 500 SERIES Service Manual page 27

Lexmark S500 Series
Error
Name
Code
1217 Printhead Temperature Error
1218 Serial Flash Error
1219 Undefined Signal Error
2100 Unlock Scanner
2200 Scan Carrier Stall
2-8
Service Manual
Description
There is a problem determining
temperature.
Invalid parameters have been
passed to ReadFlashPage.
Microprocessor has
encountered a bad signal
(other than an abort, illegal
instruction, or arithmetic
exception).
Scanner mechanism is locked
in place or unable to move due
to other failure.
The scan carrier has stalled.
Action
Technical Support Center:
Check and clean the contacts. If the
problem persists, then replace the
printhead.
Service:
Check and clean the contacts. If the
problem persists, then replace the
printhead.
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the All-In-
One.
Service:
Replace the system board. See
board removal" on page
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See
board removal" on page
Technical Support Center:
Replace the All-In-One.
Service:
Replace the scanner assembly. See
"Scanner assembly removal" on
page 4-3.
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in, and turn the power on. If the
problem remains, then replace the All-In-
One.
Service:
Replace the scanner assembly. See
"Scanner assembly removal" on
page 4-3.
"System
4-26.
"System
4-26.