How To Turn On The Pg-700 - Furuno PG-700 Operator's Manual

2. OPERATION
2.2

How to Turn on the PG-700

The unit has no power switch. Supply the +12 VDC power via the optional junction box FI-5002 or
FURUNO CAN bus device. When power is received by the sensor, the unit will automatically
check ROM and RAM status. After this, the lamps light as shown below:
CALIB
CALIB
CALIB
CALIB
CALIB
Angular velocity sensor initialization
CALIB
Note: If there is a problem with the ROM and/or RAM, the CALIB and CHECK lamps turn off, and
the STATUS lamp flashes red. Contact your dealer.
STATUS CHECK
STATUS CHECK
STATUS CHECK
STATUS CHECK
STATUS CHECK
(Approx. two minutes)
STATUS CHECK
Normal display
: ON (green)
: ON (red/green)
: OFF
: Flashing (green)
14