Wiring - Furuno PG-700 Operator's Manual

Integrated heading sensor
Table of Contents

Advertisement

1.2

Wiring

Connect a termination resistor at both ends of the backbone of CAN bus devices. PG-700 incor-
porates a termination resistor. Turn the switch on/off as applicable.
If using the optional Junction Box FI-5002
Connect the unit and the FI-5002 using cable M12-05BM+05BF-060 (supplied as installation ma-
terials). For connection at the FI-5002, cut the cable at the pre-connected connector, fabricate the
cable as shown below, then connect the cable to the MC connector at the FI-5002. Ground the
unit to the hull using the shortest IV-2sq cable possible.
*2
Crimp-on lug
(inner dia. 3mm)
Ground wire*2
IV-2sq
To ground
*1: Turn the Termination switch
OFF to connect CN3 - CN5;
ON to connect CN2.
*2: Prepared locally
• How to fabricate cable M12-05BM+05BF-060 and connect MC connector
6 mm
Cable Fabrication
Core
M12-05BM+05BF-060 (6m)
Termination switch*1
FI-5002
Power cable (2m)
Red
+
Sensor
PG-700
12VDC
Fix cable with
supplied cable ties.
Drain wire
Sheath
Screw
Twist
MC connector
1. HOW TO INSTALL THE EQUIPMENT
Connect to
CN2 - CN5.
Black
12VDC
Wire
Drain
RED
BLK
WHT
BLU
How to insert cores:
1. Twist core.
2. Unfasten screw with flathead screwdriver.
3. Set core to hole.
4. Tighten screw.
5. Pull wire to confirm connection.
5
Side view
CN3 - CN5
CN2
DROP
BACKBONE
MC connector
Top view
JUNCTION BOX
FI-5002 (option)
Conn. Pt.
1
2
3
4
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents