Image Shape; Adjusting Image Shape Using The Control Panel Thumbstick - Epson Pro Cinema LS10500 User Manual

1 Center of lens
2 Projected image when lens shift is set in the center
3 Maximum vertical range (V × 90%)
4 Maximum horizontal range (H × 40%)
Note: You cannot move the image to both the horizontal and vertical maximum values.
5. When you are finished, press the Esc button on the control panel or remote control.
Note: When adjusting the image height, position the image lower than where you want it to be and then
move it up. This will help prevent the image from moving down after adjustment.
Parent topic:

Image Shape

You can project an evenly rectangular image by placing the projector directly in front of the center of the
screen and keeping it level. If you place the projector at an angle to the screen, or tilted up or down, you
may need to correct the image shape for the best display quality.

Adjusting Image Shape Using the Control Panel Thumbstick

Parent topic:
Adjusting Image Shape Using the Control Panel Thumbstick
You can use the thumbstick on the projector's control panel to correct the shape of an image that is
unevenly rectangular on the sides.
Note: To provide the best possible image quality, adjust the projector's position to correct the image
shape. If this isn't possible, use keystone correction to correct the image shape.
Note: Keystone corrections are most effective within a projection angle of 30° from top to bottom.
1. Turn on the projector and display an image.
Note: You can display a pattern to aid in adjusting the projected image using the Settings menu.
Adjusting the Image Height
Using Basic Projector Features
59