Special Mode; Special Mode Setting Button (For 1913E3 Model) - Denon AVR-1913 Service Manual

SPECIAL MODE

Special mode setting button (for 1913E3 model)

b No.1 - 5 : Press the "Power operation ( X )" button to turn on the power while pressing both the buttons A, B and the button C at
the same time.
b No.6 : Turn on the power, then press and hold down the A and B buttons for over 3 seconds.
b No.7 : Turn on the power, then press and hold down the A and B buttons for over 10 seconds.
No. Mode
Version display
1
(μcom/DSP Error Display)
User Initialization mode
2 (Installer Setup settings are not
initialized.)
Factory Initialization mode
3 (Installer Setup settings are also
initialized.)
PANEL/REMOTE LOCK Selection
4
mode
5 Service Related Selection mode
6 Remote ID Setup mode
7 NETWORK Initialization mode
Button A Button B
STATUS DIMMER
SOURCE SOURCE
SELECT 1 SELECT 0
ZONE2
DIMMER
SOURCE
ZONE2 SOURCE
SOURCE SELECT 1
ZONE2
DIMMER
SOURCE
STATUS DIMMER
ZONE2
DIMMER
SOURCE
SOURCE SELECT 0
ZONE2 SOURCE
X SOURCE SELECT 1
Button C
Firmware versions such as Main or DSP are displayed in
– the FL Display. Errors are displayed when they occur. (Refer
to 23 page)
Backup data initialization is carried out.
–
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
–
(Installer Setup settings are also initialized.)
Selects to reject operations through panel buttons and the
– master volume knob on the main unit and operations via
the remote control.
Selects the "Diagnostic mode" or "Displaying the protection
STATUS
history mode".
When using multiple DENON AV receivers in the same
– room, make this setting so that only the desired AV receiver
operates. (Refer to 33 page)
– Initializes NETWORK related settings.
DIMMER
STATUS
21
Contents
f