Special Mode; Special Mode Setting Button (For E400E3 Model) - Denon AVR-E400 Service Manual

SPECIAL MODE

Special mode setting button (for E400E3 model)

b No.1 - 5 , 7 : Press the "Power operation ( X )" button to turn on the power while pressing both the buttons A, B and the button C at
the same time.
b No.6 , 8 : Turn on the power, then press and hold down the A and B buttons for over 3 seconds.
b No.9 : Turn on the power, then press and hold down the A and B buttons for over 10 seconds.
No. Mode
Version display
1
(μcom/DSP Error Display)
User Initialization mode
2 (Installer Setup settings are not
initialized.)
Factory Initialization mode
3 (Installer Setup settings are also
initialized.)
PANEL/REMOTE LOCK Selection
4
mode
5 Service Related Selection mode
6 Remote ID Setup mode
7 Protection pass mode
8 DM860A Reboot mode
9 NETWORK Initialization mode
SOURCE SELECT 0
Button A Button B
STATUS DIMMER
SOURCE SOURCE
SELECT 1 SELECT 0
ZONE2
DIMMER
SOURCE
ZONE2 SOURCE
SOURCE SELECT 1
ZONE2
DIMMER
SOURCE
STATUS DIMMER
SOURCE
STATUS
SELECT 0
SOURCE SOURCE
SELECT 1 SELECT 0
ZONE2
DIMMER
SOURCE
X
ZONE2 SOURCE
SOURCE SELECT 1
Button C
Firmware versions such as Main or DSP are
– displayed in the FL Display. Errors are displayed
when they occur. (Refer to
Backup data initialization is carried out.
–
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
–
(Installer Setup settings are also initialized.)
Selects to reject operations through panel buttons
– and the master volume knob on the main unit and
operations via the remote control.
Selects the "Diagnostic mode" or "Displaying the
STATUS
protection history mode".
When using multiple DENON AV receivers in the
– same room, make this setting so that only the desired
AV receiver operates. (Refer to
ZONE2 Turns the power on with the Protection detection
SOURCE disabled.
Restarts DM860.
– Initializes NETWORK related settings.
DIMMER
STATUS
22
Contents
24 page)
50 page)