Lennox SLP98DFV Installation Instructions Manual page 34

®
icomfort Wi-Fi Thermostat with SLP98DFV
and Non-Communicating Outdoor Unit
®
icomfort Wi-Fi Thermostat
®
icomfort -Enabled SLP98DFV Indoor Furnace
Non-Communicating Outdoor Air Conditioner
icomfort
ENABLED
SLP98DFV
FURNACE
OPTIONAL
DISCHARGE
AIR SENSOR
®
icomfort Wi-Fi
THERMOSTAT
CLIP Y1 TO Y2 FOR
TWO-STAGE OPERATION
Outdoor Unit
Communicating systems using the IcomfortWi-Fi
mostat wires between the thermostat and the furnace/air handler control and four
wires between
mostat cable with more than four wires is used, the extra wires must be properly
connected to avoid electrical noise. The wires must not be left disconnected.
Use wire nuts to bundle the four unused wires at each end of the cable. A
single wire should then be connected to the indoor unit end of the wire bundle
and attached to the "C" terminals as shown in the diagram above.
®
-
OPTIONAL
OUTDOOR
AIR SENSOR
NON-COMMUNICATING
OUTDOOR AIR
CONDITIONING UNIT -
1 OR 2 STAGE
Indoor Unit
Controller
Single wire to
terminal C
Unused wires
®
icomfort Wi-Fi
and icomfort
®
icomfort Wi-Fi Thermostat
®
icomfort -Enabled SLP98DFV Indoor Furnace
®
icomfort -Enabled Outdoor Air Conditioner or Heat Pump
OPTIONAL
DISCHARGE
AIR SENSOR
OPTIONAL
OUTDOOR
AIR SENSOR
®
icomfort Wi-Fi
THERMOSTAT
Single wire to
terminal C
Unused wires
®
FIGURE 44
Page 34
Thermostat with SLP98DFV
®
-ENABLED Outdoor Unit
®
icomfort -
ENABLED
SLP98DFV
FURNACE
icomfort
OUTDOOR AIR CONDITIONING
OR HEAT PUMP UNIT
®
IcomfortWi-Fi
thermostat
®
- ENABLED