Table of Contents
Advertisement
19. Tighten the outside set screw to be sure it is fully seated in the slot in the header.
20. Loosen the set screw ½- turn.
21. Rotate the housing to the desired position (Max. 180
screw.
22. Carefully align and connect the Sensor Ribbon Cable to connector "J4" at the bottom of the
Communication module board. When installing the Communication module in the next step,
be careful not to pinch the Sensor Ribbon Cable.
23. Carefully, insert the Communication module into the Electronics compartment. Ensure that
the Sensor Ribbon Cable is not pinched.
24. Tighten the two Communication module retaining screws.
25. If applicable, re-install the Display module as follows:
a) Orient the display as desired.
b) Install the Interface Connector in the Display module such that it will mate with
the socket for the display in the Communication module.
c) Carefully line up the display, and snap it into place. Verify that the two tabs on the
sides of the display latch.
Orient the Display for proper viewing through the end cap window.
You can rotate the meter mounting orientation in 90
26. Connect the bracket to the Transmitter housing.
27. Recalibrate the Transmitter per Section 6 "Calibration" of this document.
28. Return the Transmitter to service, and turn ON power
29. Verify the Transmitter configuration data. Restore the saved database if necessary.
30. Lubricate the end-cap O-ring with Parker Super O-ring silicone lubricant or equivalent before
replacing the end caps.
5.6 PILD Option Licensing
The PILD option can be enabled after the transmitter is shipped by purchasing and activating a
license.
To obtain and activate a license for the PILD option:
Obtain the device's Serial Number from the local display menu or from the host interface.
Reference document PILD Upgrade Option, ST 800 Instruction (#34-ST-33-73) for firmware
revision level requirements.
Place an order for PILD Field Upgrade for ST 800, part number 50097038-501 with the
Serial Number.
Based on this information the regional distribution centre will generate and return a license
key.
The license is activated by entering the License Key parameter value from the local display
menu or host interface.
Page 68
ST 800 SmartLine Pressure Transmitters User's Manual
o
in either direction), and tighten the set
o
increments.
Revision 10
Advertisement
Table of Contents
