Nat; General Screen - ZyXEL Communications armor z2 NT8700-ROG User Manual

Table 21 Network > WAN > Internet Connection: PPTP Encapsulation (continued)
LABEL
WAN MAC Address
Once the WAN MAC address is successfully configured, the address will be copied to the configuration file. It
will not change unless you change the setting or upload a different configuration file.
Factory default
Clone the
computer's MAC
address
Set WAN MAC
Address
Multicast Setup
Multicast Setup
Auto-Subnet Configuration
Enable Auto-IP-
Change Mode
Apply
Cancel

10.5 NAT

Use this screen to change your NBG6817's NAT (Network Address Translation) settings. Click
Expert Mode > WAN > NAT.

10.5.1 General Screen

Use this screen to enable NAT, set a default server and configure your NBG6817's port forwarding
settings to forward incoming service requests to the server(s) on your local network. Click Expert
Mode > WAN > NAT > General.
Chapter 10 WAN
DESCRIPTION
Select this option to have the WAN interface use the factory assigned default MAC
address. By default, the NBG6817 uses the factory assigned MAC address to identify
itself.
Select this option to have the WAN interface use a different MAC address by cloning the
MAC address of another device or computer. Enter the IP address of the device or
computer whose MAC you are cloning.
Select this option to have the WAN interface use a manually specified MAC address.
Enter the MAC address in the fields.
Select IGMPv1/v2 to enable multicasting. This applies to traffic routed from the WAN
to the LAN.
Select None to disable this feature. This may cause incoming traffic to be dropped or
sent to all connected network devices.
Select this option to have the NBG6817 change its LAN IP address to 10.0.0.1 or
192.168.1.1 accordingly when the NBG6817 gets a dynamic WAN IP address in the
same subnet as the LAN IP address.
Select this option to have the NBG6817 change its LAN IP address to 10.0.0.1 or
192.168.1.1 accordingly when the NBG6817 gets a DNS server IP address in the same
subnet as the LAN IP address.
The NAT, DHCP server and firewall functions on the NBG6817 are still available in this
mode.
Click Apply to save your changes back to the NBG6817.
Click Cancel to begin configuring this screen afresh.
NBG6817 User's Guide
86