LG GX500 Service Manual page 113

5. DOWNLOAD & S/W UPGRADE
1. Connect cable within the device.
2. Windows will pop-up Found new hardware wizard and detect the new usb device.
3. Check "Install the software automatically (Recommended)" button,
install driver for the device. (or set specific location.)
1. Connect cable within the device.
4. In case of Infineon, "Flash Loader utility" will be installed.
1. Connect cable within the device.
2. Windows will pop-up Found new hardware wizard and detect the new usb device.
In case of Neptune, "LGE GSM Device OMAPV1030" will be installed.
2. Windows will pop-up Found new hardware wizard and detect the new usb device.
3. Check "Install the software automatically (Recommended)" button,
5. If you have several usb ports for usb download, you have to repeat
3. Check "Install the software automatically (Recommended)" button,
install driver for the device. (or set specific location.)
installation from No. 1 to No. 3 for each the usb port.
install driver for the device. (or set specific location.)
4. In case of Infineon, "Flash Loader utility" will be installed.
4. In case of Infineon, "Flash Loader utility" will be installed.
In case of Neptune, "LGE GSM Device OMAPV1030" will be installed.
In case of Neptune, "LGE GSM Device OMAPV1030" will be installed.
5. If you have several usb ports for usb download, you have to repeat
5. If you have several usb ports for usb download, you have to repeat
installation from No. 1 to No. 3 for each the usb port.
installation from No. 1 to No. 3 for each the usb port.
Eg. In case of Infineon, "Flash Loader utility" will be installed as shown below.
Eg. In case of Infineon, "Flash Loader utility" will be installed as shown below.
Eg. In case of Infineon, "Flash Loader utility" will be installed as shown below.
LGE Internal Use Only
, y
, y
, y
- 114 -
Copyright © 2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes