Navien NPE-180A Installation Manual page 32

Heating MAX Set-point (P.10)
To change the heating MAX set-point:
1. In the Parameter information time mode, use the Up (+) or Down (-) buttons to
select P.10. Then, press the Info button to enter the Heating MAX set-point mode.
2. In the Heating MAX set-point mode, use the Up (+) or Down (-) buttons to
change the value and press the Info button to set to the desired mode.
Item
Heating MAX set-
point
Unavailable
Note
 If no buttons are pressed for 10 seconds or if the Info button is pressed, the
current parameter value will be saved automatically.
 To return to the <PARAMETER INFORMATION MENU MODE>, press the [Reset]
button once.
 If no buttons are pressed for five minutes, the display will automatically return to
the <PARAMETER INFORMATION MENU MODE>.
32 Configuring the NPE-180A/240A Water Heater
Description
 Sets the Heating MAX Set-point
when outdoor reset is ON (DIP switch
#1 'OFF') (Default: 180 ℉ (82 ℃ ))
 Range: 136 ℉ (57.5 ℃ ) – 180 ℉
(82 ℃ )
 Cannot be lower than the [CH MIN
set-point + 36 ℉ (20 ℃ )]
Outdoor reset is OFF (DIP switch #1 'ON')
Display