Starting And Operation; Filling With Petrol; Safety Checks; Checking The Engine Oil Level - Stiga PARK UNLIMITED Instructions For Use Manual

EN
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.

4 STARTING AND OPERATION

The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.

4.1 Filling with petrol

Always use lead-free petrol. You must never use 2-
stroke petrol mixed with oil.
The tank holds 12 litres. The level can easily be
read through the transparent tank.
NOTE! Ordinary lead-free petrol is a perishable
and must not be stored for more than 30 days.
Environmental petrol can be used, i.e. alkylate
petrol. This type of petrol has a composition that is
less harmful for people and nature.
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with petrol outdoors,
and never smoke when filling or top-
ping up. Fill up with fuel before starting
the engine. Never remove the filler cap
or fill with petrol while the engine is
running or still warm.
Never completely fill the petrol tank. Leave an
empty space (= at least the entire filler tube plus 1
- 2 cm at the top of the tank) to allow the petrol to
expand when it warms up without overflowing.
See fig. 9.

4.2 Checking the engine oil level

On delivery, the crankcase is filled with SAE 10W-
40 oil.
Always check the oil level before use to ensure it
is correct. The machine should be standing on
level ground.
Wipe around the dipstick. Unscrew and
pull it up. Wipe the dipstick.
Push the dipstick down completely and screw into
place.
Unscrew and pull the dipstick up again. Read off
the oil level.
Top up with oil to the "FULL" mark if the oil level
is below this mark. See fig. 10-12.
56
ENGLISH
The oil level must never exceed the "FULL" mark.
This results in the engine overheating. If the oil
level exceeds the "FULL" mark, the oil must be
drained until the correct level is achieved.
4.3 Level check, transmission oil
On delivery, the crankcase is filled with SAE 10W-
40 oil.
Always check the oil level before use to ensure it
is correct. The machine should be standing on
level ground.
1. Place the machine on a flat surface.
2. Read off the oil level in the reservoir. See fig.
18. The level should be level with the line.
3. If necessary, top up with more oil.

4.4 Safety checks

Check that the results of the safety checks below
are achieved when testing the machine in question.
The safety checks must always be car-
ried out every time before use.
If any of the results below is not
achieved, the machine must not be
used! Take the machine to a service
workshop for repair.
4.4.1 General safety check
Object
Fuel lines and con-
nections.
Electrical cables.
Exhaust system.
Oil lines
Drive the machine
forwards/back-
wards and release
the driving-service
brake pedal.
Test driving
Result
No leaks.
All insulation intact.
No mechanical damage.
No leaks at connections.
All screws tightened.
No leaks. No damage.
The machine will stop.
No abnormal vibrations.
No abnormal sound.