Table of Contents
Advertisement
Operating Manual - nX, nXe, and nXp 150W/75W Power Amplifiers
11.4 WR-5 Programmable Button Controller
(nXp, limited nXe)
The WR-5
(see WR-5 owner's manual)
is a programmable button remote control which mounts into a standard US electrical
wall box and is wired to the four back panel data port pins labeled "G, +18, Out, and In". Maximum wire length is 1000 ft us-
ing #24 gauge twisted pair. A decora cover plate (not included) can be purchased at hardware stores to cover the electrical box
and satisfy the aesthetic needs of the installation. The WR-5 is phantom powered from the amplifier. Up to four different WR-5
remotes can be wired in series and phantom powered from one amplifier, and more remotes can be added by using an Ashly
RPS-18 remote power supply or equivalent. To avoid potential static discharge disruptions to the WR-5 or its data signal, be
sure to connect the decora plate and WR-5 frame directly to earth ground at the point of installation. Do not use the data ground
wire as earth ground.
11.4 - WR-5 Wiring
WR-5 buttons are programmed from Protea
software after the
ne
WR-5 is wired to the amplifier and assigned a unique ID number
in its WR-5 device window. Controlled functions include preset
recall/scroll, mute, zone source selection, individual channel and
matrix point level control. Each button has a status LED. A clear
window is provided for custom button labels.
11.5 RD-8C Serial Data Fader Control
(nXp only)
The RD-8C and RW-8C are eight channel remote slide fader
controllers which connect to the amplifier's data port pins "G,
+18, Out, and In" for assignable remote level control of ampli-
fier input, matrix mixer, or output gain stages. Maximum cable
length is 1000 ft using #24 gauge twisted pair. The RD-8C is a
desktop controller, while the RW-8C mounts as a wall plate using
a standard North American 4-gang electrical box. Both units use
Euroblock connectors for wiring.. There are eight channels and
a master, each with a fader control and an on/off button. Note:
Only one RD-8C can be used per amplifier, and use of an RD-8C
will exclude the use of the data port for a WR-5. One or the other
11.5 - RD-8C or RW-8C Wiring
remote control device may be connected, but not both. For more
information, see the
RD-8C owner's manual
on the ashly website.
46
Advertisement
Table of Contents
