Ashly ne8250 Instruction Manual
Hide thumbs
Also See for ne8250:
- Operating manual (20 pages) ,
- Specification sheet (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Advertisement
Table of Contents
Related Manuals for Ashly ne8250
Summary of Contents for Ashly ne8250
- Page 1 Ashly Power Amplifier...
-
Page 2: Table Of Contents
4.4 Reliability ......... . 5 References 5.1 Ashly Amplifier Part Numbers ...... -
Page 3: Introduction
This document is for use with Ashly Amplifiers and ASTi equipment only. Please refer to Ashly’s website for more information. Introduction The Ashly Power Amplifier provides power to drive passive audio loudspeakers (4 or 8). Each amplifier is a network device that integrates with ASTi’s ACENet. ACENet provides a low latency, network-based audio and I/O distribution architecture for ASTi’s Telesta 4 and Voisus platforms. -
Page 4: Getting Started
Getting Started Warning: Before amplifier installation, ensure that your amplifier is not connected to power and all control levels are turned down (counterclockwise). Proper Cooling Do not block any of the amplifier ventilation vents. When using an equipment rack, mount the units directly on top of each other. -
Page 5: Powering Up The Amplifier
Powering Up the Amplifier Important: Complete section 2.1. Setup Procedure before proceeding with this section. When turning on the amplifier for the first time, follow the steps below. 1. Turn down the levels on the front panel. 2. Turn on the Power switch. The power indicator should illuminate after a short boot up sequence. -
Page 6: General Information
: Disconnect the power cord before making any change to the installation or wiring. General Information Front Indication Lights Rear Panel Connections AC Power Cord Connector- Standard IEC type 320 inlet, 120V models are 15-amp, 220–240 models are 10-amp. Voltage is indicated above IEC inlet. Output Connector- for every two channels - On Shore Technologies inc. -
Page 7: Front Panel Connections
Never use shielded cable for output wiring. Minimum Guaranteed Power - 150W per channel @ 8 Ohms - 250W per channel @ 4 Ohms Memory Devices The Ashly Amp memory devices are summarized in the table below. Volatile MCU Internal Flash 512kb MCU Internal SRAM... -
Page 8: Reliability
Ashly Amplifier Part Numbers This document refers to a specific Ashly amplifier. If purchasing an Ashly amplifier from another source, follow the part numbers below to ensure compatibility. Similar part numbers that may appear to be the same will not work consistently with ASTi’s ACENet architecture.