Before Requesting Service - Panasonic NN-GD692 Important Safety Instructions Manual

Before Requesting Service

The oven causes interference
with my TV.
Steam accumulates on the oven
door and warm air comes from
the oven vents.
I accidentally operate my
microwave oven without any
food in it.
There are humming and clicking
noises from my oven when I
cook by Combination.
The oven has an odor and
generates smoke when using
Combination and Grill function.
The fan motor continue
operating after cooking is over.
PROBLEM
Cannot turn on the oven.
Oven cannot start cooking.
"HOT" appears in the display
window.
When the oven is turning on,
there is noise coming from
Glass Tray.
" "
appears in the Display
Window.
"H97", "H98" or "H00"
appears in the Display
Window.
If it seems there is a problem with the oven, contact an authorized Service Centre.
IP4223_39X90HP_Eng_23_120626.indd 20 IP4223_39X90HP_Eng_23_120626.indd 20
ALL THESE THINGS ARE NORMAL:
Some radio and TV interference might occur when you cook with the microwave oven.
This interference is similar to the interference caused by small appliances such as
mixers, vacuums, hair dryers, etc. It does not indicate a problem with your oven.
During cooking, steam and warm air are given off from the food. Most of the steam
and warm air are removed from the oven by the air which circulates in the oven cavity.
However, some steam will condense on cooler surfaces such as inside and/or on the
oven door. This is normal and safe. Steam will disappear after the oven is cool down.
Operating the oven empty for a short time will not damage the oven. However, we do not
recommend this to be done.
These noise occur as the oven automatically switches from microwave power to Grill, to
create the Combination setting. This is normal.
It is essential that your oven is wiped out regularly particularly after cooking by
Combination or Grill. Any fat and grease that builds up on the roof and walls of the oven
will begin to smoke if not cleaned.
After using the microwave oven, the fan motor will operate for several minutes to cool the
electric compenents.
POSSIBLE CAUSE
The oven is not plugged in securely.
Circuit breaker or fuse is tripped or
blown.
There is a problem with the outlet.
The door is not closed completely.
Start Button was not pressed after
programming.
Another program has already been
entered into the oven.
The program has not been entered
correctly.
Stop/Reset Button has been pressed
accidentally.
The cavity is overheated.
The roller ring and oven bottom are
dirty.
The Child Lock was activated by
pressing Start Button 3 times.
The display indicates a problem with
microwave generation system.
- Eng-20 -
REMEDY
Remove plug from outlet, wait 10 seconds
and re-insert.
Contact the specified service centre.
Plug another appliance into the outlet to
check if the outlet is working.
Close the oven door securely.
Press Start Button.
Press Stop/Reset Button to cancel the
previous program and program again.
Program again according to the Operating
Instructions.
Program oven again.
Operate again after it cools down.
Clean these parts according to "Care of
Your Microware Oven" (See next page).
Deactivate Lock by pressing Stop/Reset
Button 3 times.
Contact the specified service centre.
2012-6-26 16:05:56 2012-6-26 16:05:56