Texas Instruments 880 User Manual page 29

5. Press the Accept key to select 12 CPI. (Or,
you can keep pressing the Change key,
and the other CPI choices will be listed until
you press the Accept key to select one.)
The printer now underlines your choice for
CPI and lists the current LPI (lines per inch)
selection, as shown in this example.
FONT = DRAFT ENHANCED
CPI = 10 12
LPI= 6
6. Press the Change key. The printer now
shows the next choice for LPI, which is 8
lines per inch, as shown below.
FONT = DRAFT ENHANCED
CPI = 10 12
LPI= 6 8-
7. Press the Accept key to select 8 LPI. (Or,
you can keep pressing the Change key,
. and the other LPI choices will be listed until
you press the Accept key to select one.)
The printer now underlines your choice for
LPI and lists the current state of the perfor-
ation skip feature, as shown in this
example.
FONT = DRAFT ENHANCED
CPI= 10 12
LPI = 6 8
PERFSKIP = OFF
8. Press the Change key. The printer now
shows the other choice for the perforation
skip feature, as in the following example.
FONT = DRAFT ENHANCED
CPI = 10 12
LPI= 6 8
PERFSKIP = OFF ON
9. Press the Accept key to turn on the perfor-
ation skip feature. The printer underlines
your choice and prints a new form report
based on the four selections you just made,
as shown below.
FORM: PRTFEA = H; FONT = ENHANCED;
CPI = 12;LPI =8
LM = 001; RM = 158; TM = 002; 8M = 086;
FL = 088; PERFSKIP = ON
10. Press the Normal key to accept the new
form report features and return to the nor-
mal mode or press the Accept key to
accept the new form report and print the
configuration report.
NOTE
Compare this form report with the origi-
nal form report and notice thatincreas-
ing the CPI from 10 to 12 changes the
RM from 132 to 158. Increasing the LPI
from 6 to 8 and activating the perfora-
tion-skip feature changes the 8M from
66 to 86 and the FL from 66 to 88.
Changing vertical and horizontal pitch
causes the right and bottom margin
numbers and the form length number to
change as the printer maintains the
same form size. Activating the perfora-
tion-skip feature changes the TM from
001 to 002 and the 8M from 088 to 086.
See Table 5-9 for more information
regarding margins and line lengths.