Playback Functions Screen; Av In/Out Setup Screen - Panasonic SD AG-HPX171E Operating Instructions Manual

Setup menu list (continued)
RECORDING SETUP screen (continued)
Item
TIME STAMP

PLAYBACK FUNCTIONS screen

Item
AUDIO OUT

AV IN/OUT SETUP screen

Item
CMPNT/SDI SEL
SDI OUT
SDI METADATA
SDI EDH
E-108
Display
mode
(Camera) Determines whether or not date and time information will be
superimposed on the image.
ON: Superimposes date and time information on the image.
OFF: Does not superimpose date and time information on the image.
<Note>
When DATE/TIME on the DISPLAY SETUP screen is set to OFF, the
date and time information is not superimposed.
Display
mode
(MCR) Sets the audio signals to output from the AUDIO OUT pin jack when
the P2 card or the tape is played back.
CH1 · CH:
CH1 output = CH1 signals, CH2 output = CH2 signals
CH1:
CH1 output = CH1 signals, CH2 output = CH1 signals
CH:
CH1 output = CH2 signals, CH2 output = CH2 signals
CH3 · CH:
CH1 output = CH3 signals, CH2 output = CH4 signals
CH3:
CH1 output = CH3 signals, CH2 output = CH3 signals
CH:
CH1 output = CH4 signals, CH2 output = CH4 signals
Display
mode
(Camera) Selects the type of component terminal or SDI connector.
(MCR)
When SYSTEM FREQ is set to 50 Hz:
AUTO: Monitor with D4 terminal (720P/1080i/576i output)
1080i: Monitor with D3 terminal (1080i/576i output)
576i: Monitor with D1 terminal (576i output)
When SYSTEM FREQ is set to 59.9 Hz:
AUTO: Monitor with D4 terminal (720P/1080i/480i output)
1080i: Monitor with D3 terminal (1080i/480i output)
80i: Monitor with D1 terminal (480i output)
Only video recorded at 720P is cross-converted to 1080i. Cross-
conversion does not take place in other cases.
(Camera) Selects video output from component terminal or SDI OUT terminal.
ON: Video is not output via the component terminal but from the SDI
(MCR)
connector.
OFF: Video is output via the component terminal but not from the SDI
connector.
(Camera) Determines whether or not metadata is superimposed on SDI signals
(MCR) during HD-SDI output.
ON: Superimposes metadata.
OFF: Does not superimpose metadata.
(Camera) Determines whether or not EDH is superimposed on SD-SDI signals
(MCR) during SD-SDI output.
ON: Superimposes EDH.
OFF: Does not superimpose EDH.
Description of settings
Description of settings
Description of settings
___indicates the factory setting.