Panasonic SD AG-HPX171E Operating Instructions Manual page 106

Setup menu list (continued)
RECORDING SETUP screen (continued)
Item
MIC ALC
MIC GAIN 1
MIC GAIN 
5M REC CH SEL
139 TC REGEN
TC MODE
(Only when set to
59.94 Hz)
TCG
TC PRESET
E-106
Display
mode
(Camera) Sets mic level auto control to ON or OFF. (Page 53)
ON, OFF
Set to ON to reduce distortion at high input levels.
This setting does not change the audio signal recording level. Use the
AUDIO control knob to adjust the audio signal recording level.
(Camera) Sets the input level of the external microphone connected to the INPUT
1 terminal. (Page 52)
-50dB, -60dB
(Camera) Sets the input level of the external microphone connected to the INPUT
2 terminal. (Page 52)
-50dB, -60dB
(Camera) Selects the recording audio channel for DVCPRO and DV formats.
(Page 52)
CH, CH
<Notes>
• Even when 4CH is selected as this item's setting, the signals will be
input to two channels (always CH1 and CH2) when there are two
1394 input channels.
• Similarly, even when 4CH is selected, the 1394 output signals will be
delivered to two channels (always CH1 and CH2).
(MCR) Selects the time code used for recording the signal from equipment
connected to the 1394 terminal.
ON:
Records using the time code of the signal input through the 1394
terminal.
OFF:
Records using the time code set in TC MODE/TCG.
• If you select ON here, this has priority over the settings in TC MODE/
TCG.
• If there is no input to the 1394 terminal, the camera follows the
settings in TC MODE/TCG.
(Camera) Selects the correction mode of the internal time code generator.
DF: Uses the drop frame mode.
(MCR)
NDF: Uses the non-drop frame mode.
• The non-drop frame mode will be used when you set recording frame
rate of recording format to 24P, 24PA or 24PN.
(Camera) Sets the mode in which you advance the time code.
(MCR)
FREE RUN:
The time code is advanced regardless of the operation mode.
• When setting a frame rate other than 25P (24P) during operation with
the 720P/25PN (720P/24PN) format, the FREE RUN operation for
the time code will not be performed, and the REC RUN operation will
be performed instead. It is the same when setting a frame rate other
than 30P during operation with the 720P/30PN format.
REC RUN:
The time code is advanced only when recording.
(Camera) Sets the initial time code.
(MCR) • Set the frame value to 0 or a multiple of 5 when you set recording
frame rate of recording format to 24P, 24PA or 24PN. If any other
value, the recorded time code will mis-match.
Description of settings
___indicates the factory setting.