Clevo P170EM Service Manual page 43

Processor Installation Procedure
1. Insert the CPU
FORCE IT!), and turn the release latch
2. Remove the sticker
3. Insert the heat sink unit
4. Tighten the CPU heat sink screws in the order
15d).
5. Replace the CPU fan, component bay cover and tighten the screws
a.
A
b.
B
Downloaded from www.Manualslib.com
, pay careful attention to the pin alignment
A
towards the lock symbol
B
(Figure 15c) from the heat sink unit.
C
as indicated in Figure
D
,
1
c.
C
d.
2
4
manuals search engine
(Figure 15a), it will fit only one way (DO NOT
(Figure 15b).
15c.
&
, (the order as indicated on the label and
2 3 4
(page 2 - 17).
D
Note:
Tighten the screws in the order 1-2-
3-4 as indicated on the label.
1
3
a. Insert the CPU.
b. Turn the release latch to-
Figure
wards the lock symbol.
c. Remove the sticker from
the heat sink unit and in-
sert the heat sink.
d. Tighten the screws.
A. CPU
D. Heat Sink
• 4 Screws
Removing and Installing the Processor 2 - 19
Disassembly
Figure 15
Processor
Installation
