Network - Mitsubishi Electric AE-200A Instruction Book

5-2-6. Network

Touch [Initial Settings] in the menu bar, and then touch [Network].
Make necessary basic system settings such as LAN settings, M-NET settings, and external input settings for each
AE-200, AE-50, and EW-50, and then touch [Save Settings]. A message will appear asking whether or not to restart
the controller. Touch [OK] to restart the AE-200/AE-50 to reflect the changes.
Note: The Network settings may not be accessible if logged in as a building manager.
Note: The [Controller] setting will appear (only on the AE-200's LCD) when the [System Exp] setting on the [Unit Info.] screen is set
to [Expand]. Switch the [Controller] setting between [AE200] and [Exp1] through [Exp4] to make settings for each AE-200,
AE-50, and EW-50 individually.
Important
● Network settings for the AE-50/EW-50 must be made with the AE-50/EW-50 properly connected to ensure proper settings.
Those settings made without the connection of AE-50/EW-50 will not be reflected.
1st page
Controller
Select [AE] to make
settings for AE-200, and
select [1], [2], [3], or [4]
to make settings for each
AE-50/EW-50.
LAN1 Settings
Set the IP address and
subnet mask.
LAN common settings
Set the gateway address.
Touch to go to the next
page.
2nd page
LAN2 Settings
(Used for BACnet ® function
only).
Touch to go to the previous
page.
* BACnet is a registered trademark of ASHRAE (American Society of Heating, Refrigerating and Air-Conditioning Engineers, INC.).
®
WT07982X03
66
M-NET Settings
Set the M-NET address
and range of prohibited
controllers.
External Input Setting
Set the external signal input
mode.
Save Settings
Touch to save the changes
made.