Furuno DS-60 Installation Manual page 26

1. INSTALLATION
3) Apply silicon rubber to M10 bolts as shown below.
Seal washer Seal washer
2. Connect the TTYCS-4 cable to the DS-600 through the cable glands for the DS-
605.
1) Fabricate the cable as shown below.
TTYCYS-4
M3 7
x2
2) Pass the clamping gland, washer (26-003-1607), gasket (26-003-1605) and
washer (supplied as installation materials) onto the cable, in that order.
3) Pass the cable through the cable gland as
shown below.
4) Open the front cover of the DS-605 and con-
nect the ground wire attached inside the DS-
605 to the ground terminal on the rear of the
DS-600.
5) Connect the cables to the DS-600. Refer to
chapter 2.
3. Remove each binding head screw from four cor-
ners of the DS-605 and set the DS-600 to the
DS-605. These screws can be discarded.
4. Apply silicon grease to the binding head screws
included in CP66-01731 and fix the DS-600 to
the DS-605 with four binding head screws.
5. Tighten the clamping glands to fix the cables.
6. Apply putty to the cable glands for waterproofing.
7. Connect the ground terminal for the DS-605 to the ground terminal on the hull with
the IV-1.25 sq. wire.
1-20
Apply silicon rubber. Apply silicon rubber.
M10 bolt M10 bolt
Nut Nut
80
35
Shield
Fold back and wrap internal shield
and fix it by cable clamp.
130
Vinyl seath
Vinyl tape
Gasket*
Vinyl seath
Armor
*: Attached inside
the cable gland
Washer*
Clamping gasket
{
TTYCYS-4 cable