Installation
(continued)
Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
1 . If installing optional 4" Leg Accessory (item# 00956300), place a
12 .7 cm (5") spacer underneath the dispenser to ease installation .
2 . Remove four plastic, thread-protecting plugs from bottom of
dispenser .
3 . Screw each leg into chassis (Fig . 3) .
8
Dispenser and Ice Machine 230 V/50 Hz, Rear Drain
Fig . 3
spacer
12.7 cm (5")
min.