Follett E7CI100A Installation, Operation And Service Manual page 11

11 . Locate the storage bin drain tube pinch clamp (Fig . 7) and
engage (close) .
12 . E7 Series: Mix 0 .621 L (21 oz .) or 3 packets SafeCLEAN
Plus with 11 .4 L (3 gallons) of 38 C (100 F) potable water .
E15 Series: Mix 1 .24 L (42 oz .) or 6 packets SafeCLEAN
Plus with 22 .7 L (6 gallons) of 38 C (100 F) potable water .
13 . Pour cleaning solution into bin lid access spout until
solution reaches and remains level at the spout neck .
(Because the cleaning solution reaches the internal
components via overflow into the ice transport tube, it is
necessary to add cleaning solution until it remains level at
the spout neck .)
14 . Allow the solution to remain in unit for 15 minutes .
15 . While machine is cleaning, remove top and right side
panel to access and clean air-cooled condenser .
16 . Submerge ice dispense chute in the remainder of solution
for 2 minutes . Rinse with clean, potable water .
17 . Drain system: (1) release (open) the storage bin drain tube
pinch clamp and (2) lower water reservoir drain tube into
bucket .
18 . Secure capped water reservoir drain tube into holder and
engage (close) storage bin drain tube pinch clamp .
19 . Fill and drain three times with potable water . Secure water
reservoir drain tube and release (open) the storage bin
drain tube pinch clamp .
20 . Place a bucket under the dispense chute and remove cap .
Note: Some solution will remain and drain out when cap is
removed . Reposition cap on bin lid spout .
21 . Reinstall front panel, ice dispense chute, and drip tray .
22 . Press and hold maintenance/clean switch to exit
Maintenance Mode .
Fig . 7
Dispenser and Ice Machine 230 V/50 Hz, Rear Drain 11