FX Configurator-FP
Operation Manual
7.4
Verifying [positioning parameters, servo parameters table information]
Verifying the following FX Configurator-FP data with the 20SSC-H BFM.
• Positioning parameters
• Servo parameters
• Table information
1
Operate any of the following procedures
• Click
[Verify module data].
• Select [Online] → [Verify module data].
[Verify module data] dialog box appears.
2
Select the data to be verified.
Item
COM port
Transmission speed
Module No.
Item
Positioning parameters
Servo parameters
Table information
<OK>
<Cancel>
7.4 Verifying [positioning parameters, servo parameters table information]
Displays [COM port] in [Connection setup] dialog box
Displays [Transmission speed] in [Connection setup] dialog box
Displays [Module No.] in [Connection setup] dialog box
Ticks off the data to be verified
Ticks off the axis of positioning parameters to be verified
• X-axis
• Y-axis
Ticks off the axis of servo parameters to be verified
• X-axis
• Y-axis
Sets the verifying range after ticking off the axis of table information to be verified
Setting range : 0 to 299
• X-axis
• Y-axis
• XY-axis
verifies the selected data by FX Configurator-FP and the BFM
Cancels selecting and closes the dialog box
7 Read / Write / Verify / Initialize
Description
1
2
3
4
5
6
7
8
9
10
59