Initializing The Bfm And Flash Rom - Mitsubishi FX3UC Series Operation Manual

FX Configurator-FP
Operation Manual
7.5

Initializing the BFM and Flash ROM

Initializing [positioning parameters, servo parameters and table information] in the 20SSC-H BFM and Flash
ROM.
1
Select [Online] → [Initialize module].
[Initialize module] dialog box appears.
2
Select the data to be initialized.
Item
COM port
Transmission speed
Module No.
Item
Positioning parameters
Servo parameters
Table information
Flash ROM write
<OK>
<Cancel>
3
Click <OK>.
FX Configurator-FP initializes the selected data in the 20SSC-H BFM.
Caution
While data on the X- or Y-axis cannot be initialized, data on both the X- and Y-axes stored in the unit cannot
be initialized.
Wait until data on both the X- and Y-axes can be initialized, and then initialize the unit.
Displays [COM port] in [Connection setup] dialog box
Displays [Transmission speed] in [Connection setup] dialog box
Displays [Module No.] in [Connection setup] dialog box
Ticks off the data to be initialized
Ticks off the axis of positioning parameters to be initialized
• X-axis
• Y-axis
Ticks off the axis of servo parameters to be initialized
• X-axis
• Y-axis
Ticks off the axis of table information to be initialized
• X-axis
• Y-axis
• XY-axis
Ticks off when initializing the Flash ROM data selected in [Item]
Initializes the selected data
Cancels selecting and closes the dialog box
→ For the displayed messages, refer to Section 7.6.
7 Read / Write / Verify / Initialize
7.5 Initializing the BFM and Flash ROM
Description
1
2
3
4
5
6
7
8
9
10
61