Troubleshooting - Haier HVS1200 Operation Manual

Engligh

Troubleshooting

The following circumstances do not constitute problems. Do not contact the maintenance service until
the problem has been confi rmed.
Problem
The washing machine fails
to operate
Washing machine cannot
be fi lled with water
The machine is draining while
is being fi lled
Drainage failure
Strong vibration during spin drying
Operation stops before completion
of a wash cycle
Operation stops for a period of
time
Excessive foam in the drum,
which is is spilled to the
distribution drawer
Possible cause
Poor connection to power sup ply
Power failure
Door is not properly closed (It will show E1)
Machine has not been switched on
Water tap is not turned on (It will show E4)
Water pressure is less than 0.03M pa
The inlet hose is kinked
Water supply failure
The program dial is not properly set
The door is not properly clos ed
The inlet hose fi lter is blocked
The height of the drainage hose is below 80cm
(it should be within 80-100cm)
The drainage hose end is in wa ter
Drainage hose is blocked (It will show E2)
Drainage hose end is exceed 100cm above the fl oor level
The fi lter is blocked
Not all packing bolts have been removed
Washing machine is located on an uneven surface
Machine load is over 5 kg.
Water or electricity failure
Washing machine is in soak cycle
Washing machine is in soak cycle
Washing machine gives an error message.
The detergent is not a low-foaming type or for manual wash
Excessive use of detergent
14 - EN