Figure 4.5 Removing The Hdd Foil; Installing The Hdd - Toshiba Satellite SERIES Maintenance Manual

5. Remove the four M3x3 screws with torque value 3.5kgf in order as indicated in Figure
NOTE: The HDD foil screws on this module are specific to the system. Screws from older
systems are not compatible and must not be used on the HDD.
CAUTION: Do not apply pressure to the top or bottom of the drive.

Installing the HDD

Install the HDD according to the following procedures and Figure 4.6.
CAUTION: To avoid damage, always hold the HDD only by its sides.
1. Place the HDD foil on the HDD.
2. Secure the HDD foil with four M3x3 screws in order as indicated in Figure 4.6.
NOTE: The HDD foil screws on this module have oversized heads and are specific to the
system. Screws from older systems are not compatible and must not be used on the HDD.
Satellite A660/ProA660 Series Maintenance Manual
Downloaded from www.Manualslib.com
4.5 and separate the HDD foil from the HDD.
M3x3*2

Figure 4.5 Removing the HDD foil

manuals search engine
4 Replacement Procedures
M3x3*2
4-13