Installing the Fingerprint Scanner Bracket
Install the fingerprint scanner bracket according to the following procedures.
1. Turn the logic upper assembly upside down.
2. Use your fingers to press and hold down the wings on either side of the fingerprint
3. Place the bottom edge of the fingerprint scanner bracket in the proper position.
4. Lower the top edge of the fingerprint scanner bracket and press down until it snaps into
Satellite A660/ProA660 Series Maintenance Manual
Downloaded from
www.Manualslib.com
scanner bracket as shown in Figure 4.23.
place.
manuals search engine
4 Replacement Procedures
4-35