Electrolux DIVA 60 cm Service Manual page 47

SERVICE OPTIONS: A single procedure is used to access the diagnostic mode, which is reserved for Service personnel:
Press and hold down buttons Options and Ok/Start at the same time
Turn on the appliance using button S0
The LCD display lights up with a welcome message
o
The first item in the diagnostic mode appears
o
When button Options is pressed repeatedly, the service functions available on the appliance appear in sequence.
The table below contains a brief description of the functions available to service personnel:
Option or Function
Display of alarms
and diagnostic
test on
components
Cancellation of
alarms in
memory
Test cycle
Pulse washing
Extra rinse
Brightness
Contrast
Water hardness
setting
To confirm the selection, press Options, OR wait 60 seconds, OR press S0 to turn the appliance off.
NB: If "Cancel" button is pressed repeatedly without confirming a choice, the system will exit the diagnostic mode and enter the cycle selection mode. When this occurs,
no programming parameter is changed.
(1) When button Ok/Start is pressed repeatedly, the options available for the function under consideration appear in sequence.
Method of activation
LCD Buttons
1 ERR CODE i
3 LED TEST
4 TEST LINE
alternating with
NUMERO CICLI XX
5 PULSE WASHING
YES
Ok/Start
(with flashing SI) (1)
6 EXTRA RINSE NO
(with flashing NO)
BRIGHTNESS 5
CONTRAST 5
HARDNESS 40-50 °T
LCD/Leds
When button O5 is pressed a second and third time, the system
displays the second and third alarm stored.
1 ERR CODE i 0
When button O5 is now pressed repeatedly, all the systems on the
machine are activated in sequence (2 TEST ATTUAT 4...12...12).
All the LEDs and the display light up The appliance then switches to the cycle selection mode.
for 30 seconds and the buzzer beeps
at the same time
The appliance then switches to the cycle selection mode.
The test cycle begins.
All steps in the cycle are displayed.
When button O5 is pressed again, SI begins flashing again
5 PULSE WASHING NO
(with flashing NO)
When button O5 is pressed again, NO begins flashing again
6 EXTRA RINSE YES
(with flashing SI)
When button O5 is pressed again, the new brightness level flashes
BRIGHTNESS
6
(with flashing 6)
When button O5 is pressed again, the new contrast level flashes
CONTRAST 6
(with flashing 6)
When button O5 is pressed again, the new hardness value flashes
HARDNESS 51-64 °T
(with flashing 51-64 °T)
47
Short description / Comment (See section 9)