Electrical Specifications; Actuators/Sensors/Ntc; Power Feed And Selection Of Programmes; Water Filling - Electrolux DIVA 60 cm Service Manual

6.2 Electrical specifications

6.2.1

Actuators/Sensors/NTC

TYPE OF COMPONENT
Wash pump
Drain pump
Heating element
Water fill solenoid
Regeneration solenoid
Detergent and rinse-aid
solenoid
Fan motor
SENSOR
Salt sensor
Rinse-aid sensor
Temperature sensor
Turbidity sensor
(on certain models, only)
Tachometric sensor
Level sensor
Door closure sensor
Anti-flooding sensor

6.3 Power feed and selection of programmes

The main board is powered directly by the terminal board. The connectors involved are E3 (neutral)
and E1 (line).
The control/display board (user interface) is powered by 5V supplied by the main board, so
programmes can be selected when the main board is turned on.
When the door is closed, the input board detects the closed contacts on switch (IP) between
connectors F1-F3 and starts the wash programme.
components.
When the door is opened, power is shut off to the various loads and the cycle is paused.

7 Water filling

7.1 Fill circuit

7.1.1

Pressure switches on fill level and anti-overflow system

•
The level of water during filling is controlled by level pressure switch
(A)
•
The anti-overflow pressure switch (B) makes sure that the level of
water during filling does not exceed the safety threshold (overflow
through the door).
7.1.2

Fill system

The fill solenoid is powered by triac on the circuit board (connector A1) through the door switch (IP) and the
anti-flooding microswitch (DA).
POWER RATING
Max 250W
Max 100W
Max 2100W
Max 10W
Max 10W
Max 10W
Max 10W
TYPE OF SIGNAL
Digital, 5 Volts
Digital, 5 Volts
Analogue, 5 Volts
Analogue, (12 Volts, max)
Frequency
Digital, High voltage
Digital, High voltage
Digital, High voltage
22
TYPE OF CONTROL
Triac
Triac
Relay
Triac
Triac
Triac
Triac
TYPE OF COMPONENT
Reed
Reed
NTC
Opto-electronic
Tachometric generator
Pressure switch
Switch
Switch
The same switch supplies power to the electrical
B
A