Secondary 7 Pin Harness - Omega REC-12 Operation And Installation Manual

Wiring Connections (cont'd) -----
>,~.;::;~:
SECONDARY 7 PIN HARNESS
YELLOW/GREEN: (-) OEM Alarm Disarm Output- This wire mimics the BLUE
unlock wire and is used for disarming factory installed alarm systems. It is a
250mA negative output.
BROWN: (-) Horn Honk Output- Connect this to the vehicle's horn switch cir-
cuit. It is a 1A negative output that is directly compatible with most horn circuits.
Add a relay if the vehicle requires higher amperage or positive polarity.
WHITE/RED: (+/-) Flashing Light Polarity Selection- This is the input to the
flashing light relay. Connect the bullet connector on the end of this wire to the
mating connector on either the RED (+) or BLACK (-) wire to select the desired-
polarity. The polarity is determined by the vehicle's light circuit.
PINK: (-) 3nd Channel Output- This wire, by default, has a 1 second 250mA
negative output whenever the "••• " transmitter is held for 3 seconds. The timing
is configurable with feature #12. It is typically used to activate accessories like
a remote start unit.
WHITE: (+/-) Light Flash Output- By default, this wire is connected to the ve-
hicle's parking light circuit. It's polarity is determined by the WHITE/RED wire.
If flashing lights are not desired, this output can be configured to operate as 4th
channel using feature #7.