Table of Contents
Advertisement
MOUNTING COMPONENTS
The Control Module: This contains electronic components so always mount
this module at a secure location inside the vehicle like under the dash. Ensure
that the module is not succeptable to moisture, excessive vibration, or exces-
sive temperatures (like next to heater hoses).
The Status Light: This may be custom mounted or placed within the included
combination holder with the valet switch. To custom mount, select a suitable
surface panel in the vehicle with high visibility from all windows and away from
moving part of the vehicle. Drill a 9/32" hole in the chosen panel, route the
light's harness through the hole and snap the light into place. Then, plug the
status light's 2 pin plug into the corresponding port on the control module.
The Valet Switch: This may be custom mounter or placed within the included
combination holder with the status light. To custom mount, select a suitable
surface panel in the vehicle that is easily accessed by the driver and, idealy,
not in plain sight. Clean the surface well and adhere the switch to the surface
using its adhesive pad. A 1/4" hole can be drilled to route/hide the wire harness
if desired. Route the harness to the control module and plug it into the corre-
sponding port.
II
Advertisement
Table of Contents
