Advertisement

L I M I T E D
L I F E T I M E
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT,
INC. (the "Company"), are warranted to be free from defects in materials and
workmanship under normal use. If a product sold by the Company proves to be
defective, the Company will repair or replace it free of charge within the first year
and thereafter all parts to be repaired will be free with only a nominal charge for
Omega's labor and return shipping, to the original owner during the lifetime of the
car in which it was originally installed.
All products for warranty repair must be sent postage prepaid to Omega
Research & Development, Inc., P.O. Box 508, Douglasville, Georgia 30133, or
send via UPS to: 981 N. Burnt Hickory Rd., Douglasville, Georgia 30134, with
bill of sale or other dated proof of purchase. This warranty is nontransferable and
does not apply to any product damaged by accident, physical or electrical misuse
BACK COVER
or abuse, improper installation, alteration, any use contrary to its intended
function, unauthorized service, fire, flood, lightning, or other acts of God.
PRINTER'S NOTE:
This warranty limits the Company's liability to the repair or replacement of
the product. The Company shall not be responsible for removal and/or reinstallation
production back cover
charges, damage to or theft of the vehicle or its contents, or any incidental or
consequential damages caused by any failure or alleged failure of the product to
is color; this is a
function properly. UNDER NO CIRCUMSTANCES SHOULD THIS
WARRANTY, OR THE PRODUCT COVERED BY IT, BE CONSTRUED
place marker cover.
AS A GUARANTEE OR INSURANCE POLICY AGAINST LOSS. The
Company neither assumes nor authorizes any person or organization to make any
warranties or assume any liability in connection with the sale, installation, or use
of this product.
This device complies with F.C.C Rules part 15. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference
and, (2) This device must accept any interference that may be received, including
interference that may cause undesired operation.
The manufacturer is not responsible for any radio TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment.
Omega Research and Development, Inc.
P. O. Box 508
Douglasville, Georgia
www.caralarm.com
W A R R A N T Y
30133
07/08 MO-RS-310 REV1
Omega
RS-310
OPERATION MANUAL
FRONT COVER
PRINTER'S NOTE:
production front cover
is color; this is a
place marker cover.
COPYRIGHT 2007: OMEGA RESEARCH & DEVELOPMENT, INC.

Advertisement

Table of Contents
loading

Summary of Contents for Omega RS-310

  • Page 1 RS-310 Omega's labor and return shipping, to the original owner during the lifetime of the car in which it was originally installed. All products for warranty repair must be sent postage prepaid to Omega Research &...
  • Page 2: Table Of Contents

    10 Min. 5 min. 15 min. 20 min. Transmitter Overview ..............Steady/Flash Lights Rem. Start Steady Flashing Using the RS-310 System ............5-9 Confirmation Chirps/Volume Loud On Demand/Loud Locking The Doors ............... Pulsed Horn / Steady Siren Pulsed Lo Pulsed Med.
  • Page 3 Run 3 Minutes described on the following page. The remote transmitter has four push- This feature when turned on configures the RS-310 to automatically keep the engine button switches, each being labeled with an icon as to function. running briefly after it is turned off. This operation is designed specifically for...
  • Page 4: The Transmitter

    CR2032 (or 2 CR2016 batteries) coin- press “start” button to program Total Closure Lock Output type battery and reassemble the transmitter. This single feature gives the installer several needed options, to match the RS-310’s doorlocking outputs to suite different vehicle requirements. “lock” •...
  • Page 5: Using The Rs-310 System

    • Pressing and releasing this button twice locks or unlocks the system This feature selects the RS-310 processor’s method of determining the status of the without the confirmation chirps. engine running during remote start operation. As explained in feature 4’s descrip- ”start”...
  • Page 6 If you decide not to drive your car after remote starting, you can simply Installer The Excalibur RS-310’s 6 Programmable Features press & release the “|||” button again to deactivate the remote start. Other- “Tachless” or “Tach Wire” Starter Operations wise, the system will “time-out”...
  • Page 7: Using The Valet Switch

    Feature #1 Remote Start Run Time To Activate Panic Mode: Factory Default Setting 10 Minutes Press & Hold the LOCK or UNLOCK button for 3 seconds press “lock” button to program Options: THE PARKING 5 Minutes press “unlock” button to program LIGHTS WILL FLASH REPEATEDLY press “trunk”...
  • Page 8: Other Remote Start Features

    With the engine running, hold the brake pedal and engage the parking described in detail in the following pages. brake. When the brake pedal is released, the RS-310 will keep the engine running for the selected time, and then automatically turn it off.
  • Page 9: Optional Status Light Functions

    Once the Unauthorized Transmitter Alert feature is turned on, the The turbo timer feature must be programmed by the installer, and turning it warning will sound for 48 hours after any transmitter programming, including on offers three run time choices- 1, 2, or 3 minutes. The system may be the programming session which was used to turn it on.
  • Page 10: Transmitter Protection

    How to Program Transmitters Whenever the system is placed into Valet Mode, the Status Light The RS-310 system is capable of being operated by as many as four illuminates solid. However, when this first occurs, the Status Light will flash transmitters.

Table of Contents