l
oading continuous forms
s
etting uP continuous forms
To avoid paper feeding problems, carry out the following:
3cm
1.
Check your printer is on a surface approximately 75 cm above
the floor.
2.
Position the continuous forms supply directly below the printer,
no more than 3 cm left or right of the printer paper path.
3.
Ensure the rear of the printer is close to and parallel with the
edge of the surface and at least 60 cm from any wall.
f
eeding continuous forms
1.
Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in
cut sheet paper" on page
2.
Set the Paper Type Lever to Continuous Forms
24.
ML1120 Plus/ML1190 Plus User's Guide - Paper handling > 25
75cm
60cm
"Ejecting
.