Paper Handling; Loading Continuous Forms - Oki ML5721 User Manual

P
APER HANDLING
This section describes how to use cut sheet paper and continuous forms in your printer.
L
OADING CONTINUOUS FORMS
Setting up continuous forms
1. To avoid paper feeding problems, carry out the following:Check your printer is on a
surface approximately 75 cm above the floor.
2.
Position the continuous forms supply directly below the printer, no more than 3 cm
left or right of the printer paper path.
3. Ensure the rear of the printer is close to and parallel with the edge of the surface
and at least 60 cm from any wall.
Rear feed (Push)
Bottom feed (Pull)
NOTE
When the optional Pull Tractor is used.
75 cm
3 cm
75 cm
3 cm
Paper handling > 18
60 cm
60 cm