Pentair IntelliComm Installation And User Manual page 21

Priming Mode
(Continued)
6.
To set the System Priming Time:
Priming Time" setting. After the pump is primed it will take sometime before the
system is primed. This time is called "System Priming Time" To enter the maximum
system priming time, see step 7.
The "System Priming Time" value is entered in minutes, from 0 to 5 minutes. The
default is 0 minutes. Remember that the average unit will prime in a short period of
time because the IntelliFlo has the ability to monitor itself to make sure it is primed.
"System Priming Time" is for systems that require high flows that priming flow can
provide but it is deemed that more time is needed to fully relieve all the air. The
builder can program a pre determined amount of time, up to 5 minutes, to aid in
relieving the air from difficult filters or complex vertical plumbing. The "System
Priming Time" should only be used where large air traps become problems within
the system. The display will inform the user when this is engaged and when it is
finished during the priming cycle at each start up cycle.
7. Press the Select button to change the current value.
8. To change the value, press the Left and Right arrows to select which digit to modify,
then use the Up and Down arrows to change the selected digit.
9. When you are done, press the Enter button to save the changes. To cancel any
changes, press the Escape button to exit edit mode without saving.
Press the Select button to access the "System
IntelliFlo
Priming Priming
15.MIN 15.MIN
Max Priming Time Max Priming Time
Back
Filter Vacuum
Wash
Enter
On
Warn.
Alarm
Feature Feature Start
1 2 Stop
IntelliFlo
Priming Priming
0.MIN 0.MIN
System Priming Time System Priming Time
Back
Filter Vacuum
Wash
Enter
On
Warn.
Alarm
Feature Feature Start
1 2 Stop
IntelliFlo Installation and User's Guide
15
®
12:54 12:54
Manual
Reset
®
1:03 1:03
Manual
Reset