Features 1 - 2 (Flow And Duration); To Run Feature 1 Or 2 (Flow And Duration); Features 3 - 9 (Flow, Start/Stop Time); Enabling Features 3 - 9 - Pentair IntelliComm Installation And User Manual

26
Features 1 – 2 (Flow and Duration)

To run Feature 1 or 2 (Flow and Duration)

1. Press the Feature 1 or Feature 2 button, then press the Start/Stop button. The active feature LED
will be on until the process is finished.
2. The Features screen will then start to subtract time in minutes from your duration or you can scroll
using the Up or Down arrow buttons to see the power, speed, or flow status.
The following screen shown Feature 1 initiated:
IntelliFlo ®
Feature 1 Feature 1 12:54 12:54
50.GPM 50.GPM
Set Flow Set Flow
Back
Filter Vacuum Manual
Wash
On Enter
Warn.
Alarm
Feature Feature Start
Reset
1 2 Stop
Features 3 – 9 (Flow, Start/Stop Time)
Feature 3 – 9 affect the "Filter" mode as shown on page 20.
Feature 3 – 9 are programmed by a flow rate and a start/stop time and are automatically initiated. They are
controlled by the time of day. All alerts and alarms are active in Feature mode. Feature 3 – 9 must be
enabled in its menu.
Enabling Features 3 – 9
To use any Feature 3 – 9 it must be first enabled. If it is not enabled, it will not work with the parameters in
the "Set Flow" and "Set Start Time" and "Set Stop Time" settings. Features 3 – 9 are each programmed in
the same way. Three parameters are required after Enabling; Flow, Start, and Stop.
To use the Feature 3 settings; Enabled, Set Flow, Set Start Time, and Set Stop Time:
1. Ensure that the green power LED is on and the pump is stopped.
2. Press the Menu button. Press the Up or Down arrows to select the "Features" menu. Press the
Down arrow button to select Feature 3. Press the Select button to access the Feature 3 menu
settings. The Features 3 menu setting is displayed.
IntelliFlo Installation and User's Guide
IntelliFlo ®
Feature 1 Feature 1 3:02 3:02
0:01 0:01
Time Duration Time Duration
Back
Filter Vacuum Manual
Wash
On Enter
Warn.
Alarm
Feature Feature Start
Reset
1 2 Stop
®
IntelliFlo
FEATURE 1 FEATURE 1 5:01 5:01
Time remaining in minutes
1.MIN 1.MIN
REMAINING TIME REMAINING TIME
Pump run status
RUNNING RUNNING
Back
Filter Vacuum Manual
Wash
On Enter
Warn.
Alarm
Feature Feature Start
Reset
1 2 Stop
Start / Stop LED on
Feature 1 LED on