Table of Contents
Advertisement
Available languages
Available languages
EN•ENGLISH
• IMPORTANT: read the instructions
carefully before using the stroller. Save the
instructions for future reference.
• PEG PEREGO reserves the right to make any
necessary changes or improvements to the
products shown at any time without notice.
CUSTOMER SERVICE
If parts of the model are accidentally lost or
damaged, use only original Peg Perego spare
parts. Contact the Peg Perego Customer
Service for all repair work, replacements,
information about products, and sale of
original spare parts and accessories, at the
following:
USA:
tel.: 800.671.1701
fax: 260.471.6332
Call us toll free: 1.800.671.1701
CANADA:
tel.: 905.839.3371
fax: 905.839.9542
Call us toll free: 1.800.661.5050
www.pegperego.com
INSTRUCTIONS FOR USE
OPENING
1• Before opening the stroller remove the
two protective caps from the hooks
as shown in the figure. Otherwise, the
stroller will not open correctly.
2• To open the stroller, pull up the two
levers on the handles and
3• at the same time, lift the stroller, which
will open automatically. To make sure
that the stroller has been set up correctly,
check the two side hooks (see figure).
ASSEMBLYING THE STROLLER
4• To mount the front wheels, lower Lever
A and slip the wheels onto the axle,
as shown in the figure. Press until the
wheels click into place.
5• To mount the rear wheels, slip the wheels
onto the axle, as shown in the figure.
Press until the wheels click into place.
6• The stroller comes with caps on the
armrests. To attach the front bar, remove
the caps first. (Keep the caps, in case
you want to use the stroller without the
front bar). To remove the caps, press the
buttons under the armrests while pulling
the caps off.
7• To attach the front bar, insert the two
ends of the bar into the armrests and
press until the bar clicks into place, as
shown in the figure.
8• To mount the basket, slide the slots onto
the front hooks A and the rear hooks B
and C.
9• The figure shows the mounted basket.
10• The drink-holder can be attached to the
left or the right handle of the stroller,
using the two bands.
• To mount the drink-holder to the handle,
widen the clamp and fasten as shown in
the figure.
11• Slide the clamp in the drink-holder until
it clicks.
Do not put hot drinks in the drink-holder,
nor items weighing more than 1 kg (2.2
lbs).
PLIKO P3 VERSION
12• "Classico" Model: comes with a hood and
front bar-child tray. (WARNING: Never
place boiling-hot drinks on the front bar-
child tray.)
HOOD
• The hood comes with a zipper, for
attaching the zip-on rain canopy or
mosquito netting (see Accessories Line).
13• To mount the hood, push the fittings
down until they click, as shown in the
figure.
14• As shown in the figure, button the hood
inside the armrest and the backrest of the
stroller.
15• To stretch out the hood, push the
compass downward. The hood can be
reclined by following the inclination of
the backrest.
16• The hood has a zipper on the back. With
the zipper open, the hood can be used as
a sun canopy.
17• To remove the hood, you must unbutton
it from the stroller, loosen the couplings
and raise the tabs of the fasteners,
pushing towards the inside of the stroller.
BRAKE
18• To apply the brakes, push down with
one foot the bars on the rear wheels,
as shown in the figure. To release the
brakes, draw the bar up. Always set the
brakes on the stroller when it is not in
motion.
SAFETY BELT
19• A: Make sure that the brace is properly
inserted by pushing as shown in the
figure. B: Fasten the belt as shown in the
figure.
20• To unfasten the belt, press on the buckle
sides and pull out the waist strap.
21• The new safety belt is now easier to
fasten thanks to the "snap-open-and-
shut" device. Before fastening the safety
belt, attach the buckle to the backrest
by inserting the tab through the special
Hide quick links:
Advertisement
Table of Contents
