Flue Baffle And Secondary Air Tube Installation - Regency F2402M Owner's And Installation Manual

FLUE BAFFLE &
SECONDARY AIR TUBE INSTALLATION
The flue baffle system located in the upper area of the firebox is removable to make cleaning your flue system easier. The baffles must be installed prior to
your first fire. Smoke spillage and draft problems may occur if the baffles are improperly positioned. Check the position of the baffles on a regular
basis as they can be dislodged if too much fuel is forced into the firebox.
Freestanding Heater
The unit arrives with the 2 baffles on the floor of the firebox.
1) If all 4 air tubes are installed continue on to Step 2, if not, follow the
instructions below.
Air Tube Installation
Install the air tube into the holes in the side channels. The notch goes
on the right hand side with the air holes facing toward the door. Slide
the tube into the left hand side, as far as possible and then bring it
back into the hole on the right hand side until it locks into position.
If the tube will not slide in easily, simply use a pair of vise grips or
pliers and tap it into place with a hammer. A tighter fit will ensure
the tube will not move when the unit is burning.
2) Slide the left baffle over the air tubes from the front and then push it
to the back (see Diagram 1).
3) Tilt the left baffle up on top of the side channel and it will leave enough
room to position the right baffle in the same manner as Step 1 above
(see Diagram 2).
a) Insert baffle clip in between air tube and baffle,slide clip to one
side (see Diagram 3).
Then reposition the left baffle flat on the air tubes.
4) Important: push both baffles so they are tight against the side
walls and back wall (see Diagram 4).
4a)
Slide baffle clip into the centre (see Diagram 4).
Note: When getting the flue cleaned, push the baffles forward toward
the front of the heater, this should leave sufficient access to
the flue. If it is not enough space then remove the middle air
tube (reverse the procedure in step 1) above), and baffle and
then replace everything when cleaning is completed.
F2400/S2400 Freestanding Woodfire
Side View - Diagram1
Front View - Diagram 2
Baffle Clip
Side View - Diagram 3
Front View - Diagram 4
installation
11